[. . . ] The countertop must be bonded with heat resistant (212 °F/100 °C) adhesive to prevent distortion or dissolving. The cooktop should only be installed as shown in the illustrations while maintaining the required safety distances shown. Do not install the cooktop between two tall cabinets, this is a fire hazard. [. . . ] (See "Important Safety instructions"). 7 Installation Setting the cooktop into place Securing the cooktop ^ Secure the cooktop with the included fixing bracket. Countertop 13/16" (20 mm) d c ^ After removing the protective backing, d, stick the supplied seal, c, under the edge of the cooktop. (See "Gas Connection - Gas pressure regulator". ) ^ Feed the power cord through the cut-out to the power outlet. Install the appliance so that the power cord and gas piping does not come in contact with any portion of the cooktop which may become hot during use. Countertop 1 9/16" (40 mm) 8 Installation Important The cooktop must not be permanently sealed into the countertop when installed. The sealing strip under the edge of the cooktop provides a sufficient seal. If the cooktop is sealed into position, the countertop or appliance may be damaged if the cooktop needs to be removed for maintenance or service. 9 Electrical connection This appliance must be electrically grounded according to local or national codes. All electrical work should be performed by a qualified electrician in accordance with local codes and the: National Electrical Code ANSI / NFPA No. 70 for the USA To guarantee the electrical safety of this appliance, continuity must exist between the appliance and an effective grounding system. If there is any doubt, have the electrical system of the house checked by a qualified electrician. The manufacturer cannot be held responsible for damages caused by the lack, or inadequacy, of an effective grounding system. Note to the installer: Please leave these instructions with the consumer or the appliance. This appliance is equipped with a three-prong grounding plug to prevent shock hazards. If the plug does not fit the outlet, have a proper outlet installed by a licensed electrician. or - Canadian Electrical Code Part I for Canada (CSA Standard C 22. 1). WARNING: Disconnect the appliance from the main power supply before installation or service. [. . . ] Make sure that any drawers, cabinet doors, etc. , do not rub on this gas hose. If there is any doubt concerning installation contact the Miele Technical Service Department at: U 1-800-999-1360 techserv@mieleusa. com V 1-800-565-6435 service@miele. ca a Cooktop b ½" NPT c Regulator As shown in the above diagram, the included regulator must be used when connecting the Miele cooktop to your gas supply. This item has been customized by Miele to meet all applicable safety requirements. [. . . ]